Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Multi Function Display (MFD)
- Check that the Multi-Function Display (MFD) function operates normally.
- After inspection, clear the memory.
CAUTION:
If the delivery mode fuse is removed, the DTC related to the MFD is recorded.
For the installation procedure of the delivery mode fuse, be sure to refer to "FUSE INSTALLATION" in "Pre-delivery Inspection". Ref. to PRE-DELIVERY INSPECTION>PRE-DELIVERY INSPECTION (EDI) PROCEDURE>FUSE INSTALLATION .
For the installation procedure of the delivery mode fuse, be sure to refer to "FUSE INSTALLATION" in "Pre-delivery Inspection". Ref. to PRE-DELIVERY INSPECTION>PRE-DELIVERY INSPECTION (EDI) PROCEDURE>FUSE INSTALLATION .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.