Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Quick Charging
Charge the battery in a short period of time with a relatively large current by using a quick charger. Charge the battery with the current value at approximately 1/2 of battery's rating capacity. (See the table below.)
CAUTION:
- Quick charging is accompanied by a large amount of heat generation. Charging should be completed in up to 30 minutes regardless of battery size.
- Quick charging is used to recover the battery until it can start the vehicle. For full charging, use the normal charging method.
- Keep the electrolyte temperature at 55Β°C (131Β°F) or less while quick charging. Stop charging when the temperature exceeds this value.
| Type | Charging current (A) | CCA (A) |
|---|---|---|
| Q-85 | 27.5 - 32.5 | 620 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
