CAUTION:

Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
Side impact sensor (under the rear center seat) for the airbag system is located under the front center of the rear seat cushion. Be careful not to apply strong impact to the sensor when working with the rear seat cushion removed.

Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to GROUND TERMINAL REMOVAL OR INSTALLATION .
Remove the rear seat cushion assembly. Ref. to SEATS>REAR SEAT>REMOVAL .
Remove the trim panel assembly apron LH and the trim panel assembly D pillar LH. Ref. to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>REMOVAL .

Remove the power rear gate control module.

Disconnect the connectors in the following (a) - (c) order.

Courtesy of SUBARU OF AMERICA, INC.

NOTE: When the connectors are not disconnected in the sequence, a diagnosis code (DTC) may be detected.

Courtesy of SUBARU OF AMERICA, INC.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Power Rear Gate Control Module: Removal