Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Crosstrek HybridFACTORY OEM SERVICE PROCEDURE
General Tool
| TOOL NAME | REMARKS | |
|---|---|---|
| Insulated gloves | Used for removing/installing and inspecting high voltage components. | |
| Goggles | ||
| Rubber boots for electrical purposes, insulated protective shoes or insulating mat | ||
| Insulating sheet | ||
| Insulated tools | Insulated 10-mm socket | |
| Insulated extension | ||
| Insulated ratchet handle | ||
| Insulated torque wrench | ||
| Insulated flat tip screwdriver | ||
| TORX PLUS® 40IP | Used for removing and installing high-pressure fuel pump. | |
| Circuit tester | Used for measuring resistance, voltage and current. | |
| Oscilloscope | Used for inspecting the manifold absolute pressure sensor. | |
| Mighty Vac | Used for measuring resistance, voltage and current. | |
| DST-i | Used together with Subaru Select Monitor 4. | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.