2021 Subaru Crosstrek HybridFACTORY OEM SERVICE PROCEDURE

Fuel Filler Pipe: Installation

NOTE: For the installation procedure of fuel filler lid, refer to "Fuel filler lid". Ref. to SECURITY AND LOCKS>REMOTE OPENERS>INSTALLATION>FUEL LID OPENER (HYBRID MODEL) .
  1. Open the fuel filler lid.
  2. Insert the fuel filler pipe assembly into the ring clip from inside of the rear fender.
  3. Install the nuts securing the fuel filler pipe assembly.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

    G13231005Courtesy of SUBARU OF AMERICA, INC.
  4. Install the bolts securing the fuel filler pipe assembly.

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  5. Connect the fuel filler hose (A) to the fuel filler pipe assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO(HEV))>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>FUEL FILLER HOSE CONNECTION>FILLER PIPE SIDE .
  6. Connect the circulate tube assembly (B) to the fuel filler pipe assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO(HEV))>FUEL DELIVERY AND EVAPORATION LINES>INSTALLATION>QUICK CONNECTOR CONNECTION (TYPE F) .
    G13231004Courtesy of SUBARU OF AMERICA, INC.
  7. Install the mud guard - rear RH. Ref. to EXTERIOR/INTERIOR TRIM>MUD GUARD>INSTALLATION .
  8. Install the rear sub frame assembly. Ref. to REAR SUSPENSION>SUB FRAME>INSTALLATION .
  9. Install the fuel filler pipe protector.
Chapter Navigation
Return to Chapter: Fuel Filler Pipe
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.