2021 Subaru Crosstrek Base, Automatic CVT TransFACTORY OEM SERVICE PROCEDURE

Oil Level Switch: Installation

  1. Use a new O-ring to install the oil level switch, and install the clip to the oil pan upper.
    NOTE: Apply engine oil to O-ring.

    Tightening torque:Β 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

  2. Connect the connector and install the clip.
  3. Install the engine mounting LH.

    Tightening torque:Β 

    35 N.m (3.6 kgf-m, 25.8 ft-lb)

  4. Lower the engine and remove the lifting device and wire ropes.
  5. Remove the ST1 and ST2 from the engine unit. (Except for hybrid model)
    G11253302Courtesy of SUBARU OF AMERICA, INC.
  6. Install the front drive shaft LH. Ref. to DRIVE SHAFT SYSTEM>FRONT DRIVE SHAFT>INSTALLATION .
  7. Install the electric power steering gearbox. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>ELECTRIC POWER STEERING GEARBOX>INSTALLATION .
  8. Install the nuts which hold the engine mounting to the front crossmember. (CVT model)
    CAUTION: Use new nuts.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.