Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE
Transmission Harness: Removal
- Remove the transmission body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Transmission Assembly>REMOVAL .
- Disconnect the transmission ground.
- Disconnect the harness connector from the secondary speed sensor (A), front wheel speed sensor (B), primary speed sensor (C), secondary pressure sensor (D), and inhibitor switch (E).
- Remove the harness stay from the transmission harness connector and inhibitor harness connector.
- Remove the torque converter. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Torque Converter>REMOVAL .
- Install the ST and place the transmission body.NOTE:
- When attaching the ST to the (a) positions, spacers or similar of 2.0 mm (0.08 in) or more in thickness are necessary.
- Prepare a container for draining of oil, because CVTF remaining inside the transmission body may flow out from the input shaft portion.
Preparation tool:
ST: STAND ASSY (18632AA000)
- Remove the control valve body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Control Valve Body>REMOVAL .
- Remove the bolt securing the transmission harness.
- Remove all clips and remove the transmission harness.
- Remove the O-rings.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
