2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Front Reduction Driven Gear: Adjustment

  1. If the ball bearing is attached, remove the ball bearing and front reduction driven gear shim (front side). Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>Converter Case Cover>REMOVALΒ .
  2. Using the ST, measure height "A" from the ST upper face to the converter case mating surface.

    Preparation tool:Β 

    ST: GAUGE (398643600)

    G13864193Courtesy of SUBARU OF AMERICA, INC.
  3. Measure depth "B" from the converter case cover upper face to the ball bearing catch surface.
    G13864194Courtesy of SUBARU OF AMERICA, INC.
  4. Install a new ball bearing to the reduction driven gear.
  5. Measure depth "C" from the ST upper face to the ball bearing end face using the ST.

    Preparation tool:Β 

    ST: GAUGE (398643600)

    G13200379Courtesy of SUBARU OF AMERICA, INC.
  6. Calculate clearance "T" using the following formula.

    Formula: T mm = (C - 15) - ((A - 15) - B)

    [T in = (C - 0.591) - ((A - 0.591) - B)]

    T: Clearance

    A: Height from the ST upper face to the converter case mating surface

    B: Depth from the converter case cover upper face to the ball bearing catch surface

    C: Depth from the ST upper face to the ball bearing end surface

    15 mm (0.591 in): Thickness of ST

    Clearance "T" mm (in) Front reduction driven gear shim (front side) thickness mm (in)
    0.470 - 0.569 (0.019 - 0.021) 0.4 (0.016)
    0.570 - 0.669 (0.022 - 0.025) 0.5 (0.020)
    0.670 - 0.769 (0.026 - 0.029) 0.6 (0.024)
    0.770 - 0.869 (0.030 - 0.033) 0.7 (0.028)
    0.870 - 0.980 (0.034 - 0.039) 0.8 (0.031)
  7. Select one to two front reduction driven gear shims (front side) so that the front reduction driven gear shim (front side) thickness meets the value obtained from the above.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.