Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE
Inspection Mode H
| DTC | Item | Condition |
|---|---|---|
| P0746 | PRESSURE CONTROL SOLENOID "A" PERFORMANCE/STUCK OFF | - |
| P0747 | PRESSURE CONTROL SOLENOID "A" STUCK ON | - |
| P2723 | PRESSURE CONTROL SOLENOID "E" PERFORMANCE/STUCK OFF | - |
Diagnostic procedure:
- Check the readiness code using Subaru Select Monitor and confirm that the diagnosis is not completed.
- Start the engine.
- Drive in any driving pattern for 20 minutes. (Include driving at a constant legal speed (for 20 seconds) at least once.)
- Turn the ignition switch to OFF, and wait for 30 seconds or more.
- Start the engine.NOTE: Repeat two driving cycles in this driving pattern.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.