Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE
Ball Joint: Installation
CAUTION:
For parts which are not reusable, always use new parts.
- Install the ball joint COMPL to the front axle housing.CAUTION:
- Do not apply grease to the tapered portion of ball stud.
- Be careful not to damage the boot of the joint.
- Before tightening, make sure the bottom surface of front axle housing and stepped section of ball joint COMPL are in contact.
Tightening torque:Β
50 N.m (5.1 kgf-m, 36.9 ft-lb)
- Install the ball joint COMPL into the arm COMPL front.
- Connect the ball joint COMPL to the arm COMPL front.
Tightening torque:Β
39 N.m (4.0 kgf-m, 28.8 ft-lb)
- Retighten the castle nut further up to 60Β° until the hole in the ball stud is aligned with a slot in the castle nut.
- Insert a new cotter pin and bend it around the castle nut.
- Connect the ball joint COMPL to the arm COMPL front.
- Install the under cover front.
Tightening torque:Β
18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Lower the vehicle, and install the front wheels.
Tightening torque:Β
120 N.m (12.2 kgf-m, 88.5 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
