2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Check Seating Sensor Mat

Preparation tool: 

Circuit tester

  1. Disconnect the connector of the seat belt switch and seating sensor mat.
  2. Measure the resistance between the terminals when the seating sensor mat is in each of the following operation conditions.
    • RH
      Terminal No. Inspection conditions Standard Circuit
      1 - 2 Do not sit on RH 1 MΩ or more
      G13864582Courtesy of SUBARU OF AMERICA, INC.
      1 - 2 Sit on RH 1 Ω or less
    • CTR
      Terminal No. Inspection conditions Standard Circuit
      1 - 2 Do not sit on CTR 1 MΩ or more
      G13864582Courtesy of SUBARU OF AMERICA, INC.
      1 - 2 Sit on CTR 1 Ω or less
    • LH
    Terminal No. Inspection conditions Standard Circuit
    1 - 2 Do not sit on LH 1 MΩ or more
    G13864582Courtesy of SUBARU OF AMERICA, INC.
    1 - 2 Sit on LH 1 Ω or less
  3. Replace the seating sensor mat together with the seat cushion pad if the inspection result is not within the standard value.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.