2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

When The CROSSMEMBER COMPL Front Was Removed

  1. Use a new O-ring to install the oil level switch, and secure the harness with the clip.
    NOTE: Apply engine oil to O-ring.

    Tightening torque:Β 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

    G13199185Courtesy of SUBARU OF AMERICA, INC.
  2. Secure the harness with clip, and connect the connector.
    G13199164Courtesy of SUBARU OF AMERICA, INC.
  3. Install the crossmember COMPL front. Ref. to FRONT SUSPENSION>Crossmember>INSTALLATION .
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.