2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

DTC U0422: Invalid Data Received From Body Control Module

DTC detecting condition:Β 

CAN data from body integrated unit is abnormal.

Trouble symptom:Β 

  • After the "Welcome" is displayed, even if the ignition is turned to ACC ON, the screen remains in black and the system does not startup.
  • When the ignition is turned to ACC ON while the "Welcome" screen is being displayed, the screen remains the same.
  • When the driver's door is opened while the "Good-bye" screen is being displayed, the screen remains the same.
  • Frequency of advice to take a rest increases.
  • Brightness of multi-function display does not change.
  • Headlight AUTO switch status is not displayed correctly in the advanced equipment screen.
  • Auto wiper status is not displayed correctly in the advanced equipment screen.
  • High beam assist status is not displayed correctly in the advanced equipment screen.
NOTE: For the diagnostic procedure, refer to DTC U0074. Ref. to MULTI-FUNCTION DISPLAY (DIAGNOSTICS)>Diagnostic Procedure with Diagnostic Trouble Code (DTC)>DTC U0074 CONTROL MODULE COMMUNICATION BUS "BODY-CAN" OFFΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.