2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Multi-function Display (MFD): Installation

CAUTION:
  • Make sure the electrical connector is connected securely.
  • Make sure that the multi-function display operates normally.
  • When reusing the tether clip of the trim panel assembly A pillar, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel assembly A pillar may come off.
  • Do not reuse the tether clip of the trim panel assembly A pillar when it is removed from the vehicle. Always replace with a new part.
  • Do not reuse the upper clips of the trim panel assembly B pillar UPR. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.
  • Before installing the trim panel assembly A pillar, check the condition of protective non-woven fabric (white) of the curtain airbag. If it is damaged (airbag module cloth is exposed), replace the curtain airbag module assembly with a new part.
  1. Connect the connector, and install the multi-function display.
  2. Install the trim panel assembly A pillar.
  3. Install the grille speaker side.
  4. Install the grille speaker assembly CTR.
  5. Install the switch assembly hazard.
  6. Install the grille ventilation assembly center.
  7. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Chapter Navigation
Return to Chapter: Multi-function Display (MFD)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.