Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Power Window Control Switch: Installation: Sub-Switch
- SWITCH ASSEMBLY POWER WINDOW FRONT SUB
For installation of the switch assembly power window front sub on the passenger's seat, refer to the installation procedure of the switch assembly power window main. Ref. to GLASS/WINDOWS/MIRRORS>Power Window Control Switch>INSTALLATION>MAIN SWITCH .
- SWITCH ASSEMBLY POWER WINDOW REAR SUB
- Install the switch assembly power window rear sub to the trim panel rear door, and connect the connector.
- Install the trim panel rear door.
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.