Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE
REINITIALIZATION Of Shade Control Module
NOTE:
This work is required when a deviation occurs between the position recognized by the shade control module and the actual position of the shade, resulting from removing/installing the motor assembly that has already been initialized and removing/installing the shade assembly.
- Turn the ignition switch to ON.
- Push the shade switch to the OPEN side, and move the shade assembly to the fully open position.
- Turn the shade switch to OFF once. Push the shade switch to the OPEN side again, and keep the condition for 10 seconds or more.
- After 10 seconds, the shade assembly moves to the fully open mechanical lock position, and then reverses and stops at the fully open position.
- It stops at the fully open position and the reinitialization of the shade control module will be complete.
NOTE:
For the operation order of shade assembly reinitialization, refer to the following figure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
