Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Power Steering Fluid: Replacement
- Lift up the vehicle.
- Drain the power steering fluid.
- Remove the pipe joint of the gearbox, and connect the vinyl hose to the pipe and the joint.
- Discharge the fluid by turning the steering wheel fully clockwise and counter clockwise.
- Add the specified fluid to the reservoir - tank assembly at "MAX" level.
- Continue to turn the steering wheel slowly from lock to lock until the bubbles stop appearing on oil surface while keeping the fluid at the level in the step 3).
- If the steering wheel is turned in a low fluid level condition, air will be sucked into the pipe. If air has entered, leave it for about half an hour and then repeat step Β 4 again.
- Start the engine and let it idle.
- Continue to turn the steering wheel slowly from lock to lock again until the bubbles stop appearing on oil surface, while keeping the fluid at the level in step 3).
Normally bubbles will stop appearing after turning the steering wheel from lock to lock three times.
- In case bubbles do not stop appearing in the tank, leave it for about half an hour and then repeat from step Β 3 again.
- Lower the vehicle, and then idle the engine.
- Continue to turn the steering wheel from lock to lock until the bubbles stop appearing and change of the fluid level is within 3 mm (0.12 in).
- In case the following happens, leave it about half an hour and then perform step Β 7 to Β 10) again.
- The fluid level changes by 3 mm (0.12 in) or more.
- Bubbles remain on the upper surface of the fluid.
- Grinding noise is generated from oil pump.
- Check the fluid leakage after turning steering wheel from lock to lock with engine running.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
