Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Service Limit
Make a measurements as follows. If it exceeds the service limit, replace with a new part.
- When securing the oil pump in a vice, hold the oil pump with the least possible force between two pieces of wood.
- Do not set the outside of flow control valve or pulley on a vise; otherwise outside or pulley might be deformed. Select properly sized wood pieces.
- Play of the pulley shaft
Condition:Β
P: When applying a force of 9.8 N (1 kgf, 2.2 lbf)
Service limit:Β
Play in the radial direction (direction β)Β
0.2 mm (0.008 in) or less
Axial play (direction β)Β
0.9 mm (0.035 in) or less
- Deflection of the pulley groove
Service limit:Β
1 mm (0.039 in) or less
NOTE: Read the value on one surface of V groove, set the dial gauge on the other surface, and read the value of the dial gauge. - Rotating resistance of pulley
Service limit:Β
Maximum load: 9.22 N (0.94 kgf, 2.07 lbf) or less
NOTE:- A rather higher value may be indicated when pulley starts turning.
- Measure the load during rotation to make a judgment.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
