2020 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Basic Inspection

Perform the following inspection procedures and replace faulty parts.

No. Parts Inspection Corrective action
1 Oil pump (exterior) (1) Crack, damage or oil leakage Replace the oil pump with a new part.
(2) Play of pulley shaft Measure the radial play and axial play. If any of these exceeds the service limit, replace the oil pump with a new part.
2 Pulley (1) Damage Replace the oil pump with a new part.
(2) Bend Measure the V groove deflection.
If it exceeds the service limit, replace the oil pump with a new part.
3 Oil pump (interior) (1) Faulty or seized of vane pump Check the rotating resistance of pulley. If it exceeds the service limit, replace the oil pump with a new part.
(2) Bend in the shaft or damage to bearing If the a string is wrapped on the pulley and rotated, and the oil pump emits a noise that is markedly different in tone and loudness from a sound of a new oil pump, replace the oil pump with a new part.
4 O-ring Cracking or deterioration Replace with a new part.
5 Bracket Cracks Replace with a new part.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.