2020 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Without DTC

Detecting condition: 

  • Defective combination meter
  • Open circuit of harness

Trouble symptom: 

  • The STEERING warning light will not turn off.
  • «No DTC» will be displayed on Subaru Select Monitor.
NOTE: When the STEERING warning light is OFF and «No DTC» is displayed on Subaru Select Monitor when all DTCs are read, the system is operating properly.
  1. CHECK LAN SYSTEM. 

    Perform the diagnosis for LAN system using the Subaru Select Monitor. Ref. to LAN SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .

    Is DTC U0131 detected?

    Yes:  Perform the diagnosis according to DTC for LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS)>LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .

    No:  Go to  2.

  2. CHECK COMBINATION METER. 

    Check the STEERING warning light when the ignition is turned from OFF to ON.

    Does the STEERING warning light illuminate at ignition switch ON, and turn off two seconds after the engine is started?

    Yes:  Finish the diagnosis.

    No:  Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.