Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Crossmember Support: Installation
- Install the crossmember support front and the crossmember support rear.
Tightening torque:
Crossmember support front: 60 N.m (6.1 kgf-m, 44.3 ft-lb)
Crossmember support rear: 70 N.m (7.1 kgf-m, 51.6 ft-lb)
- Install the under guard front. (H4DOTC model)
Tightening torque:
32 N.m (3.3 kgf-m, 23.6 ft-lb)
- Install the under cover front. Refer to Exterior/Interior Trim>Front Under Cover>Installation .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.