Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2020 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Universal Joint: Removal

Set the steering wheel to the straight-ahead position.
Adjust the tilt position of the steering column to the neutral position.
CAUTION: Always place the tilt lever to the lock position after the steering column is adjusted.
Prevent the steering wheel from turning using the seat belt.

Courtesy of SUBARU OF AMERICA, INC.
Remove the under cover front. Refer to Exterior/Interior Trim>Front Under Cover>Removal .
Remove the universal joint assembly steering.
1. Place alignment marks on the universal joint assembly steering.
  NOTE:
  Place alignment marks on the following positions.
  - Between the column assembly steering and the universal joint assembly steering
  - Between the steering gearbox assembly and the universal joint assembly steering (only when the guide is not installed)
2. Remove the bolt, and remove the universal joint assembly steering.
  CAUTION: Do not remove the guide camera.
Courtesy of SUBARU OF AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.