2020 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Other Tools

TOOLS REMARKS
Steering wheel puller Used for removing the steering wheel.
Ball joint puller Used for disconnecting tie-rod end.
Dial gauge Used for measuring the runout of steering gearbox assembly.
Magnet stand Used for measuring the runout of steering gearbox assembly.
Circuit tester Used for measuring resistance, voltage and current.
DST-i Used together with Subaru Select Monitor 4.
C-clamp Used when inspecting steering gearbox assembly.
Monkey wrench Used when adjusting steering gearbox assembly. (Tool compatible with 38 mm (1.5 in) width across flats)
12.7 mm sq (0.5 in sq) socket Used when adjusting steering gearbox assembly. (Drain plug socket, etc.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.