Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Ignition Timing: Inspection
WARNING: This page is about a different variant/trim than selected.
- Before checking the ignition timing, check the following item:
- Check the air cleaner element is free from clogging, spark plugs are in good condition, and hoses are connected properly.
- Check the malfunction indicator light does not illuminate.
- Warm up the engine.
- Read the ignition timing using Subaru Select Monitor. Refer to ENGINE (DIAGNOSTICS) (H4DOTC)>Data Monitor>OPERATION
.NOTE: If the ignition timing is out of standard, refer to the basic diagnostic procedure of "ENGINE (DIAGNOSTICS)". Refer to ENGINE (DIAGNOSTICS) (H4DOTC)>Basic Diagnostic Procedure .
Ignition timing [BTDC/{r/min}]:
Standard
0°±10°/700
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.