2020 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Inspection Mode Ac

DTC Description & trouble part Condition Number of driving cycles on the detecting condition
P26A5 ENGINE COOLANT BYPASS VALVE "A" POSITION SENSOR CIRCUIT RANGE/PERFORMANCE [Engine Coolant Temperature 1]: 0Β°C (32Β°F) or more 2
  1. Check that the battery voltage is 12 V or more and fuel remains approx. half [20 - 40 L (5.3 - 10.6 US gal, 4.4 - 8.8 Imp gal)].
  2. Using the Subaru Select Monitor, perform the clear memory of [Engine Control System]. Refer to COMMON (DIAG)>CLEAR MEMORY .
  3. Start the engine and let it idle.
  4. Turn the ignition switch to OFF and wait for approx. 3 minutes or more.
  5. Read the temporary code using the Subaru Select Monitor or general scan tool. Refer to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.