Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Mode $02 (Powertrain Freeze Frame Data)
Refer to data denoting the operating condition when trouble is detected by on-board diagnosis system. A list of the support data and PID (Parameter Identification) codes are shown in the following table.
| PID | Data | Unit |
|---|---|---|
| $02 | DTC that caused freeze frame data to be stored | - |
| $03 | Fuel system control status | - |
| $04 | Calculated engine load value | % |
| $06 | Short term fuel trim (bank 1 sensor 1) | % |
| $07 | Long term fuel trim (bank 1 sensor 1) | % |
| $0B | Intake manifold absolute pressure | kPa |
| $0C | Engine speed | rpm |
| $0D | Vehicle speed | MPH |
| $0E | Ignition timing advance | o |
| $0F | Intake air temperature | Celsius |
| $10 | Intake air amount | g/s |
| $11 | Throttle valve opening angle | % |
| $13 | Air fuel ratio sensor | - |
| $15 | Oxygen sensor output voltage and short term fuel trim associated with oxygen sensor (bank 1 sensor 2) | V and % |
| $1F | Elapsed time after starting the engine | sec |
| $24 | A/F value and A/F sensor output voltage (bank 1 sensor 1) | - and V |
| $2C | Target EGR | % |
| $2D | EGR deviation | % |
| $2E | Evaporative purge | % |
| $2F | Fuel level | % |
| $33 | Barometric pressure | kPa |
| $34 | A/F value and A/F sensor current (bank 1 sensor 1) | - and mA |
| $3C | Catalyst temperature #1 | Celsius |
| $42 | ECM power voltage | V |
| $43 | Absolute load | % |
| $44 | A/F target lambda | - |
| $45 | Relative throttle opening angle | % |
| $46 | Ambient temperature | Celsius |
| $47 | Absolute throttle opening angle 2 | % |
| $49 | Absolute accelerator opening angle 1 | % |
| $4A | Absolute accelerator opening angle 2 | % |
| $4C | Target throttle opening angle | % |
| $5C | Engine oil temperature | Celsius |
| $65 | Neutral status | - |
| $67 | Engine inlet/outlet coolant temperature | Celsius |
| $6D | Fuel pressure and target fuel pressure | kPa |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.