2020 Subaru Legacy BaseFACTORY OEM SERVICE PROCEDURE

High-Pressure Fuel Pump Case

  1. Apply liquid gasket to the mating surfaces of fuel pump case, and install the high-pressure fuel pump case.
    NOTE:
    • Before applying liquid gasket, degrease the old liquid gasket seal surface of the high- pressure fuel pump case and the cam carrier assembly LH.
    • Install within 5 min. after applying liquid gasket.

    Liquid gasket: 

    THREE BOND 1217G (Part No. K0877Y0100), THREE BOND 1217H or equivalent

    Liquid gasket applying diameter: 

    3.5±1 mm (0.1181±0.0394 in)

    G13618452Courtesy of SUBARU OF AMERICA, INC.
  2. Install the high-pressure fuel pump case.

    Tightening torque: 

    19 N.m (1.9 kgf-m, 14.0 ft-lb)

    G11252849Courtesy of SUBARU OF AMERICA, INC.
  3. Install the high-pressure fuel pump. Refer to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>HIGH PRESSURE FUEL PUMP>INSTALLATION>HIGH-PRESSURE FUEL PUMP .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.