2020 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Transfer Clutch: Installation

  1. Install the thrust bearing.
    NOTE: Make sure to install in the right direction.
    G10218706Courtesy of SUBARU OF AMERICA, INC.
  2. Install the transfer clutch.
    G08317898Courtesy of SUBARU OF AMERICA, INC.
  3. Select the transfer driven gear shim.
  4. Remove the transfer clutch from the extension case.
  5. Attach the selected transfer driven gear shim to extension case with Vaseline.
  6. Install a new seal ring to the transfer clutch.
    NOTE: Apply CVTF to the seal rings.
  7. Install a new seal ring to the transfer driven gear.
    NOTE: Apply CVTF to the seal rings.
  8. Install the transfer clutch.
  9. Install the extension case. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>EXTENSION CASE>INSTALLATIONΒ .
  10. Install the electric oil pump. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>ELECTRIC FLUID PUMP>INSTALLATIONΒ .
  11. Install the transmission body. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>TRANSMISSION ASSEMBLY>INSTALLATIONΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.