Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Front Toe-In
Toe-in: Inspection value
0±3 mm (0±0.12 in)
- Set the toe-in gauge in the position at wheel axis center height behind the right and left front tires.
- Place a mark at the center of both left and right tires, and measure distance "A" between the marks.
- Move the vehicle forward to rotate the tires 180°.NOTE: Be sure to rotate the tires in the forward direction.
- Measure the distance "B" between the left and right marks.
Find toe-in using the following calculation:
A - B = Toe-in
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.