Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Stabilizer Bushing
- Before installation, inspect the following items and replace any faulty part with a new one. Check the bushing stabilizer front for abnormal cracks, fatigue or damage.
- Install the bushing stabilizer front.
- Install the clamp stabilizer.
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Install the front exhaust pipe. Refer to EXHAUST (H4DO)>FRONT EXHAUST PIPE>INSTALLATION .
- Install the under cover front.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.