Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Steering Wheel: Assembly
CAUTION:
- Securely install the switch and the cover steering wheel LWR. Improper insertion of the pins or claws of the switch and the cover steering wheel LWR may cause improper installation.
- When installing the heater steering wheel and the cover steering wheel LWR for models with steering heater, be careful of the following:
- Attach the heater element to the cover steering wheel LWR so that it is not twisted or does not interfere with switches.
- Be careful not to allow the heater element to be caught in steering frame, unit and the cover steering wheel LWR.
- Install the switch assembly steering (MID).
- Install the steering heater switch and steering heater unit to the cover steering wheel LWR. (Model with steering heater)
- Install the satellite switch.
- Install the cover steering wheel LWR.NOTE: Secure the heater element on the cover steering wheel LWR using double-sided tape. Refer to the figure below to attach the heater element and double-sided tape symmetrically.
- Install the cover spoke.
- Install the paddle shift switch. (Model with paddle shift)
- Install the screws at two locations on upper back side of the steering wheel. (Model without paddle shift)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
