Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Oil Level Switch: Installation
- Use a new O-ring to install the oil level switch, and install the clip to the oil pan upper.NOTE: Apply engine oil to O-ring.
Tightening torque:
6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- Secure the oil level switch harness with clip, and connect the connector.
- Install the engine mounting LH.
Tightening torque:
35 N.m (3.6 kgf-m, 25.8 ft-lb)
- Lower the engine and remove the lifting device and wire ropes.
- Remove the ST.
- Install the front drive shaft LH. Refer to PROPELLER SHAFT/DRIVE SHAFT/AXLE>FRONT DRIVE SHAFT>INSTALLATION .
- Install the electric power steering gearbox. Refer to POWER ASSISTED SYSTEM (POWER STEERING)>ELECTRIC POWER STEERING GEARBOX>INSTALLATION .
- Install the nuts which hold the engine mounting to the crossmember COMPL front.CAUTION: Be sure to use a new nut.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.