2020 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE

Charging System: Inspection

Inspection when charge warning light illuminates 

NOTE: If the alternator overheats, the charge warning light illuminates temporarily.
  1. CHECK DTC. 

    Read the DTC using Subaru Select Monitor.

    Is DTC detected?

    Yes 

    1. Repair the corresponding system.
    2. Go to  2.

    No  Go to  2.

  2. CHECK V-BELT. 

    Check the V-belt for abnormalities. Refer to MECHANICAL (H4DO)>V-BELT>INSPECTION .

    Is the V-belt normal?

    Yes  Go to  3.

    No  Replace the V-belt or V-belt tensioner assembly. Refer to MECHANICAL (H4DO)>V-BELT .

  3. CHECK VOLTAGE OF GENERATOR B TERMINAL. 

    Check the voltage of the generator terminal B.

    Is the battery voltage applied?

    Yes  Go to  4.

    No  Repair the harness between generator and MAIN SBF.

  4. CHECK CONTINUITY BETWEEN GENERATOR MAIN BODY AND CHASSIS GROUND. 

    Check continuity between generator main body and chassis ground.

    Is there continuity?

    Yes  Go to  5.

    No  Check and repair the installation condition of the generator, chassis ground and engine ground. Refer to STARTING/CHARGING SYSTEMS (H4DO)>GENERATOR .

  5. CHECK COMBINATION METER. 

    Perform the self-diagnosis of combination meter. Refer to INSTRUMENTATION/DRIVER INFO>COMBINATION METER SYSTEM>OPERATION>SELF-DIAGNOSIS DISPLAY MODE .

    Is the charge warning light OK?

    Yes  Repair or replace the generator. Refer to STARTING/CHARGING SYSTEMS (H4DO)>GENERATOR .

    No  Replace the combination meter. Refer to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.