Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE
Fuel Pump Control Computer (FA20): Removal
- Disconnection of the battery ground terminal (Refer to WORKING PRECAUTIONS AND NOTES )
- Disconnection of front door opening trim weather strip RH (Refer to REMOVAL )
- Removal of the front door scuff plate RH (Refer to REMOVAL )
- Removal of separate type rear seat cushion ASSY (Refer to REMOVAL )
- Removal of luggage compartment trim cover INN RH (Refer to REMOVAL )
- Removal of luggage compartment trim side cover RH (Refer to REMOVAL
)
- Removal of fuel pump control computer ASSY
- Disconnect the fuel pump control computer connector.
- Remove the nut.
- Push in the stud bolt of fuel pump control computer ASSY
- Slide the fuel pump control computer ASSY toward the rear of the vehicle to disengage the bracket and remove the fuel pump control computer ASSY.CAUTION: If impact is applied to the fuel pump control computer ASSY, do not reuse it.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.