Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE
Fuel Pump Control Computer (FA20): Installation
- Installation of fuel pump control computer ASSY
- Engage the bracket of fuel pump control computer ASSY to the body mounting hole and pass the stud bolt through the body hole.
- Install the fuel pump control computer ASSY with the nut.
Standard value: T=5.0Nm {51kgfcm} {3.7ftlbf}
CAUTION: If impact is applied to the fuel pump control computer ASSY, do not reuse it. - Connect the fuel pump control computer connector.
- Installation of luggage compartment trim side cover RH (Refer to INSTALLATION )
- Installation of luggage compartment trim cover INN RH (Refer to INSTALLATION )
- Installation of separate type rear seat cushion ASSY (Refer to ASSEMBLY )
- Installation of the front door scuff plate RH (Refer to INSTALLATION )
- Installation of the front door opening trim weather strip RH (Refer to INSTALLATION )
- Installation of battery ground terminal
Standard value: T=6.0Nm {61kgfcm} {4.4ftlbf}
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.