Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2020 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE
Fuel Pressure Sensor (FA20): Removal
- Intake manifold removal (Refer to REMOVAL
)
- Fuel delivery pipe removal
- Remove the 3 bolts.
- Remove the fuel delivery pipe.
- Fuel delivery pipe (bank 1 side) removal
- Disconnect the fuel pressure sensor connector and two fuel injector connectors.
- Remove the two bolts and remove fuel delivery pipe (bank 1 side).
- Disconnect the fuel pressure sensor connector and two fuel injector connectors.
- Fuel pressure sensor removal
- Remove the fuel pressure sensor from the fuel delivery pipe (bank 1 side).
- Fuel injector ASSY removal (Refer to REMOVAL )
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.