2020 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Rear Wheel Toe-In

When adjusting, adjust it to the following value.

Toe-in: Adjustment value.Β 

3Β±2 mm (0.12Β±0.08 in)

  1. Loosen the self-locking nut after holding the bolt head section of rear lateral link assembly front.
    G13199290Courtesy of SUBARU OF AMERICA, INC.
  2. Turn the adjusting bolt until toe-in is within the specification.
    NOTE: When the left and right wheels are adjusted for toe-in at the same time, the movement of one scale graduation changes toe-in by approx. 6 mm (0.24 in).
    To increase toe-in.
    Rotate the left side clockwise. Rotate the right side counterclockwise.
    G12400554Courtesy of SUBARU OF AMERICA, INC.
    G13199292Courtesy of SUBARU OF AMERICA, INC.
    To decrease toe-in.
    Rotate the left side counterclockwise. Rotate the right side clockwise.
    G13199293Courtesy of SUBARU OF AMERICA, INC.
    G13199294Courtesy of SUBARU OF AMERICA, INC.
  3. Attach and tighten a new self-locking nut.

    Tightening torque:Β 

    120 N.m (12.2 kgf-m, 88.5 ft-lb)

    NOTE: While holding the adjusting bolt side, tighten the nut side.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.