Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2020 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Front Strut: Disposal

CAUTION:

Before handling the strut COMPL front and shock absorber, be sure to wear goggles to protect eyes from gas, oil and cutting powder.
Do not disassemble the strut COMPL front and the shock absorber or throw them into flames.
When discarding the strut COMPL front and the shock absorber filled with gas, drill a hole on them to purge the gas.

Place the strut COMPL front and shock absorber on a level surface with the piston rod fully expanded.
Make a hole of 30 mm (1.18 in) deep into the specified position shown in the figure, using a drill with 2 - 3 mm (0.08 - 0.12 in) diameter.

Courtesy of SUBARU OF AMERICA, INC.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.