2020 Subaru Ascent BaseFACTORY OEM SERVICE PROCEDURE

Engine Control System (Diagnostics) - Introduction: General Description: Preparation Tool: Preparation Tool

ILLUSTRATION TOOL NUMBER DESCRIPTION REMARKS
G13202287Courtesy of SUBARU OF AMERICA, INC.
- SUBARU SELECT MONITOR 4 Used for setting of each function and troubleshooting for electrical system.
NOTE: For detailed operation procedures, refer to "Help" of application.
G05018651Courtesy of SUBARU OF AMERICA, INC.
18252AA000 CRANKSHAFT SOCKET Used for rotating crankshaft.
G13198159Courtesy of SUBARU OF AMERICA, INC.
18460AA150 (Newly adopted tool) CHECK BOARD Used for measuring voltage and resistance of ECM terminals.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.