Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Subaru WRX STIFACTORY OEM SERVICE PROCEDURE
Section 18 (Engine Control System (Diagnostics) (General) (Except For STI))
WARNING: This page is about a different variant/trim than selected.
- Diagnostic Procedure Without Diagnostic Trouble Code (DTC)
- Check Si-Drive (Subaru Intelligent Drive) System
- Notes
- SI-Drive Mode Indication Does Not Change And Modes Do Not Switch After Switching Si-Drive Modes
- When The Si-Drive Mode Is Changed, "S", "I" Or "S#" Flashes In Combination Meter Si-Drive Mode Display In Approx. 5 Seconds
- When The Si-Drive Mode Is Changed, "S", "I" Or "S#" Flashes In Combination Meter Si-Drive Mode Display
- Check Si-Drive (Subaru Intelligent Drive) System
- General Diagnostic Table
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
