Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Subaru WRX STIFACTORY OEM SERVICE PROCEDURE
Throttle Sensor Inspection (Method With Subaru Select Monitor): Notes
- Turn the ignition switch to ON. (Engine OFF)
- Read the throttle opening angle signal and voltage of throttle sensor using Subaru Select Monitor. Refer to ENGINE (DIAGNOSTICS) (STI)>SUBARU SELECT MONITOR>OPERATION>DISPLAY CURRENT ENGINE DATA (NORMAL MODE) .
| Throttle sensor | Throttle opening angle signal | Standard |
|---|---|---|
| Main | 0.0% | Approx. 0.6 V |
| 100.0% | Approx. 3.96 V | |
| Sub | 0.0% | Approx. 1.48 V |
| 100.0% | Approx. 4.17 V |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
