2019 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Drive Cycle X

DTC Item Condition Number of driving cycles on the detecting condition
P2004 TGV CONTROL STUCK OPEN BANK 1 - 1
P2005 TGV CONTROL STUCK OPEN BANK 2 - 1
P2006 TGV CONTROL STUCK CLOSED BANK 1 - 1
P2007 TGV CONTROL STUCK CLOSED BANK 2 - 1
  1. Using the Subaru Select Monitor, perform the clear memory for Β«EngineΒ». Refer to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>CLEAR MEMORY MODE>OPERATIONΒ .
  2. Idle the engine for 10 seconds or more after engine start.
  3. For CVT models, set the select lever to "P" range, and for MT models, move the gear shift lever into neutral position, and then race the engine for 10 seconds or more.
    NOTE: Keep the engine speed at 3500 rpm or more.
  4. Read the temporary code using the Subaru Select Monitor or general scan tool. Refer to ENGINE (DIAGNOSTICS) (EXCEPT FOR STI)>READ DIAGNOSTIC TROUBLE CODE (DTC)>OPERATIONΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.