Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Subaru Outback 2.5iFACTORY OEM SERVICE PROCEDURE
General Scan Tool
WARNING: This page is about a different variant/trim than selected.
NOTE:
For detailed operation procedures, refer to the general scan tool operation manual.
- Perform the Clear Memory Mode. Ref. to ENGINE (DIAGNOSTICS) (H6DO)>GENERAL SCAN TOOL>OPERATION>MODE $04 (CLEAR/RESET EMISSION-RELATED DIAGNOSTIC INFORMATION) .
- Read the diagnostic trouble code (DTC) and check that no DTC is displayed. Ref. to ENGINE (DIAGNOSTICS) (H6DO)>GENERAL SCAN TOOL>OPERATION>MODE $07 (INITIAL EMISSION-RELATED POWERTRAIN DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis using "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H6DO)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC) . After solving the DTC, repeat from step 1).
- Start the engine, and run the engine at idle for 10 seconds or more.
- Read the diagnostic trouble code (DTC) and check the DTC. Ref. to ENGINE (DIAGNOSTICS) (H6DO)>GENERAL SCAN TOOL>OPERATION>MODE $07 (INITIAL EMISSION RELATED POWERTRAIN DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis using "Diagnostic Procedure with Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H6DO)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC) . After solving the DTC, repeat from step 1).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.