Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Subaru Outback 2.5iFACTORY OEM SERVICE PROCEDURE
Data Link Connector: Note
WARNING: This page is about a different variant/trim than selected.
This connector is used for Subaru Select Monitor.
CAUTION:
Do not connect any scan tools other than Subaru Select Monitor or general scan tool because the circuit for Subaru Select Monitor may be damaged.
| Terminal No. | Contents |
|---|---|
| 1 | Blank |
| 2 | Blank |
| 3 | Blank |
| 4 | Ground |
| 5 | Ground |
| 6 | CAN communication (Hi) |
| 7 | Subaru Select Monitor signal |
| 8 | IG |
| 9 | Blank |
| 10 | Blank |
| 11 | Blank |
| 12 | Blank |
| 13 | Blank |
| 14 | CAN communication (Lo) |
| 15 | A/B batch operation |
| 16 | Power supply |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.