Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Subaru Outback 2.5iFACTORY OEM SERVICE PROCEDURE
Vehicle Dynamics Control (VDC) System: General Description: Specification
| Item | Specification or identification | ||||
|---|---|---|---|---|---|
| ABS wheel speed sensor | Gap between ABS wheel speed sensor and magnetic encoder (for reference) | Front | 0.62 - 1.57 mm (0.02 - 0.062 in) | ||
| Rear | 0.58 - 1.62 mm (0.02 - 0.064 in) | ||||
| Identifications of harness (symbol) | Front | H1 | |||
| Rear | Sedan model | RH | H3 | ||
| LH | H4 | ||||
| OUTBACK model | RH | H7 | |||
| LH | H8 | ||||
| VDCCM&H/U identification | Models without EyeSight | G9 | |||
| Models with EyeSight | GA | ||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.