Secondary Speed Sensor: Inspection

1. Disconnect the ground cable from battery. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
2. Remove the clip from the air intake boot, and loosen the clamp.

   Courtesy of SUBARU OF AMERICA, INC.

3. Remove the air intake boot, and place it aside so that it does not interfere with the work.
   CAUTION: Be careful not to pull out the PCV hose.

   Courtesy of SUBARU OF AMERICA, INC.

4. Disconnect the ground cord.

   Courtesy of SUBARU OF AMERICA, INC.

5. Remove the pitching stopper. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION(TR580)>TRANSMISSION MOUNTING SYSTEM>REMOVAL>PITCHING STOPPER .
6. Remove the transmission case cover (front).

   Courtesy of SUBARU OF AMERICA, INC.

7. Move the lock lever in the arrow direction while pressing the lock button (A), and disconnect the connector.

   Courtesy of SUBARU OF AMERICA, INC.

8. Set the ST between the TCM and transmission harness. Ref. to TRANSMISSION (DIAGNOSTICS)>GENERAL DESCRIPTION>CAUTION .

   Special tool: 

   CHECK BOARD (18460AA040)

9. Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO)>AIR INTAKE BOOT>INSTALLATION .
10. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
11. Connect the probe of oscilloscope to ST.

    Courtesy of SUBARU OF AMERICA, INC.

    Terminal No.	Probe
    13	+
    26	-

12. Start the engine and warm up completely.
13. Lift up the vehicle.
    WARNING:

    • Lift up the vehicle until the tire bottom is 0.3 m (0.98 ft) or more above the ground.
    • Make sure that safety is secured where the tiers rotate.
14. Turn OFF the pre-collision brake function. (Models with EyeSight)
15. Turn the VDC function OFF.
16. Release the parking brake.
17. Shift the select lever to "D range".
18. Release the brake pedal, and rotate the tires.
19. Check the output waveforms and output voltage.
    NOTE: For the output waveform and output voltage, refer to the "TRANSMISSION (DIAGNOSTICS)" information. Ref. to TRANSMISSION (DIAGNOSTICS)>TRANSMISSION CONTROL MODULE (TCM) I/O SIGNAL>WAVEFORM>SENSOR .
20. After inspection, install the related parts in the reverse order of removal.

Courtesy of SUBARU OF AMERICA, INC.

Tightening torque: 

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.

Tightening torque: 

32.3N.m (3.3 kgf-m, 23.8 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.