Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Battery Cable Assembly: Installation
- Secure the battery cable assembly to the bracket.
- Install the clip (C) and claw (D) to the intake manifold assembly to secure the battery cable assembly.
- Connect the connector (A), and install the engine wiring harness to the clip (B).
- Secure the battery cable assembly with the clip (A) and clip (B).
- Connect the connector (C), connector (D), and the terminal (E).
Tightening torque:
15.5 N.m (1.6 kgf-m, 11.4 ft-lb)
- Connect the terminal B and connector to the starter.
Tightening torque:
11 N.m (1.1 kgf-m, 8.1 ft-lb)
- Connect the ground terminal to the cable stay.
Tightening torque:
14 N.m (1.4 kgf-m, 10.3 ft-lb)
- Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO)>AIR INTAKE BOOT>INSTALLATION .
- Connect the terminal (A), terminal (B) and the terminal (C).
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the collector cover. Ref. to INTAKE (INDUCTION) (H4DO)>COLLECTOR COVER>INSTALLATION .
- Connect the ground terminal (A) and install the ground cable to the clip (B).
Tightening torque:
13 N.m (1.3 kgf-m, 9.6 ft-lb)
- Connect the ground terminal (C) and install the battery cable holder (D).
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the battery sensor harness to the clip (E).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
