Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Subaru Forester BaseFACTORY OEM SERVICE PROCEDURE
Power Rear Gate Control Module: Removal
CAUTION:
When the power rear gate CM is replaced, the memory height function is initialized. Be sure to measure the power rear gate height before starting the operation and set the memory height function again after the operation.
- Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Remove the rear seat cushion assembly. Ref. to SEATS>REAR SEAT>REMOVAL .
- Remove the trim panel assembly apron LH and the trim panel rear pillar UPR LH. Ref. to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>REMOVAL .
- Remove the power rear gate Control Module.
- Disconnect the connectors in the following (a) - (c) order.NOTE: When the connectors are not disconnected in the sequence, a diagnosis code (DTC) may be detected.
- Release the lock and hook, and remove the power rear gate Control Module.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.