2019 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE

Filler Pipe (FA20): Removal

  1. Fuel spill prevention procedure (Refer to FUEL SYSTEM (FA20)Β )
  2. Draining of fuel (Refer to REMOVALΒ )
  3. Disconnection of the battery ground terminal (Refer to WORKING PRECAUTIONS AND NOTES )
  4. Removal of fuel filler cap
    1. Open the fuel filler lid, and remove the fuel filler cap.
      G10213554Courtesy of SUBARU OF AMERICA, INC.
    2. Turn the fuel filler pipe protector in the direction of the arrow to unlock and remove it.
  5. Removal of rear suspension member SUB-ASSY (Refer to REMOVAL )
  6. Removal of rear mud guard RH
    1. Remove the clip to remove the rear mud guard RH.
  7. Removal of filler pipe
    G10213555Courtesy of SUBARU OF AMERICA, INC.
    1. Disconnect the fuel tank to filler pipe hose (A) and vent hose (B) from the filler pipe, and disconnect the quick connector of drain tube (C).
      G10213556Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the bolts and nuts securing the filler pipe to the body.
    3. Remove the filler pipe from underside of the vehicle.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.