Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2019 Subaru BRZ Limited, Automatic TransFACTORY OEM SERVICE PROCEDURE
Oxygen Sensor (FA20): Removal
- Disconnection of the battery ground terminal (Refer to WORKING PRECAUTIONS AND NOTES )
- Removal of front tire RH
- Removal of under cover front AL (Refer to REMOVAL )
- Disconnection of under cover front side RH
- Remove 3 clips, and disconnect the under cover front side RH.
- Removal of oxygen sensor
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.